11.2.5 Filter monitoring
The filter element clogs with increasing use resulting in an increase of the pressure difference at the filter. If the resistance exceeds a limit value and if sufficient cleaning is not possible any longer, then the filter element will have to be replaced. This value is controlled by measuring the pressure difference between filter chamber entry and exit.
- Table of contents
- 1. Fields of application of abrasive blasting technology
-
2. Blasting technology
- 2.1 Airless blast cleaning
-
2.2 Injection blasting
- 2.2.1 Compressed air blasting (also air blast cleaning or sand blasting)
- 2.2.2 Pressure blasting (injector blasting)
- 2.2.3 Vacuum-compressed-air blasting and vacuum injection blasting
- 2.2.4 Damp blasting
- 2.2.5 Wet blasting
- 2.2.6 Slurry blasting
- 2.2.7 Ice Blasting
- 2.2.8 Water- jetting cleaning and hydro-jetting
- 2.2.9 Wet blasting for fine surface treatment
- 2.2.10 Combination of different blasting methods
- 2.3 Laser cleaning
- 3. Abrasive
- 4. Efficiency assessment of abrasive blasting
- 5. Influence of compressed-air blasting on the surface of the workpiece
- 6. Generation of compressed air
-
7. Plants for compressed-air blasting
- 7.1 Small and medium-sized blasting pots
- 7.2 Large blasting pots
- 7.3 Double-chamber blasting pot
- 7.4 Mixing and dosing valve
- 7.5 Hoses, lengths of hoses, couplings
- 7.6 Selection of a blasting pot in considering the wear and tear behaviour
- 7.7 Increased wear and tear at the blasting pot caused by wrong adjustment
- 8. Remote control and emergency shut-downs
- 9. Jet nozzles
- 10. Stationary blasting halls
- 11. Mobile abrasive blasting equipment
- 12. Laws and provisions